Emptying the Robot Dust Bin
Frequency: After each cleaning session or as needed
-
Press the release button on the back of the robot and slide out the dust bin.
-
Hold the dust bin over a trash can.
-
Press and hold the release button while lifting the lid using the finger slots.
-
Empty the debris into the trash.
-
Optionally, wipe the dust bin with a damp cloth.
-
Let the bin air-dry for 48 hours before reinserting.
Cleaning the Filter
Frequency: Every time you empty the dust bin
-
Remove and empty the dust bin.
-
Slide out the filter from the back of the dust bin.
-
Lightly tap the filter over a trash can to remove dust and dirt.
-
Use a dry cloth or soft brush to remove any remaining debris.
Important: Do not use water or soap to clean the filter—this may cause permanent damage.
Cleaning the Brushroll
Frequency: Regularly; replace every 6–12 months or when visibly worn
- Push up on the tabs of the brushroll door and lift it off.
- Remove the brushroll and take off the end cap.
- Clean off any hair or debris.
- Replace the cap and reinstall the brushroll, inserting the flat end first.
- Close the brushroll door and press down until both sides click into place.
Cleaning the Side Brushes
Frequency: Regularly; replace when visibly worn
-
Turn the robot over.
-
Grip the rubber base of the side brush bristles and lift to remove.
-
Remove all hair and debris from the brush.
-
Clean the side brush post on the bottom of the robot.
-
Align the square hole of the brush with the square post and press until it clicks into place.
-
Spin the brush to ensure it moves freely.
Cleaning or Replacing the Mop Pad
Frequency:
-
Auto-cleaned after each wet clean
-
Machine wash every 3 months or replace as needed
To replace:
-
Pull the pad away from the pad plate.
-
Slide it off to one side.
-
Slide a clean/new pad into the plate and press lightly to secure.
Note: Mop pad color may vary.